Description
TMT Flow Switch With Pilot Feature
|
Fits Model
Replaces OEM
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Specifications
Temperature |
40°-180° F Operating Temperature |
Inlet |
3/8" FPT |
|
Pilot: 1/4" hose barb |
|
Lead length: 48" 18awg |
|
Electrical service life: 200,000 operations |
|
Micro switch technology eliminates reed switch |
|
Highpressure inline flow switch |
|
Activates with as little as .5 gpm flow |
|
Minimal pressure drop up to 12 gpm |
|
Mount in vertical position |
|
250 VAC switching voltage maximum |
|
5 Amps switching current maximum |
|
30 OHM contact resistance with leads |
|
200,000 operations electrical service life |
|
10 million operations mechanical service life |
|
Install the flow switch VERTICALLY to the output side of the unloader, with the 2 conductor lead wires exiting from the top. If your system uses a downstream chemical injector, it should be mounted on the output side of the flow switch. Pilot model requires a direct connection to the water supply feed line to provide a pilot signal. This is accomplished by installing a tee fitting (with a 1/4" hose barb fitting) directly in the water supply feed line. The tube must be installed before the float valve. Install an appropriate length of 1/4" ID reinforced polyvinyl tubing between the tee fitting and the valve pilot port. |
Gallons Per Minute |
12 |
Outlet |
3/8" FPT |
Equipment Type |
Pressure Washer |
PSI |
4000 |
Customer Reviews for the
TMT Flow Switch With Pilot Feature
There are no reviews for this product at the time.
Repair Tips For
Barens 5193
No repair tips at this time.