JavaScript Disabled - Unable to show Cart
There are (76) parts used by this model.
- Found on Diagram:
A/C Components
-
-
14067019
RECIEVER DRIER
Diameter: 4" Length: 7 3/4" Inlet: 3/8" FO Outlet: 3/8" MO
$70.10
-
- Found on Diagram:
Bearings
-
30200005
BEARING
Ball Bearing, ID: 1.968" (50mm), OD: 3.15" (80mm), W: .63" (16mm)
$37.75
-
30200006
BEARING
Cup & Cone, ID: 1.187" (30.16mm), OD: 2.53" (64.29mm), W: 0.84" (21.43mm)
$32.15
- Found on Diagram:
Clutch, Transmission & PTO Components
-
-
-
14121012
PTO SHAFT
2 Speed PTO Stub Shaft (540/1000 RPM), LOA: 9.20", 6 x 14 x 21 spline.
$194.98
-
14125002
BEARING
ID: 1.772" (45.008mm), OD: 2.953" (75.006mm), W: .63" (16.002mm)
$32.51
-
14121017
PLANETARY PLATE
ID: 9 3/8" (238mm), OD: 13 11/16" (347mm) including 4 tabs.
$54.08
-
-
14126004
CLUTCH DISC
ID: 4 7/8" (125mm) with 50 teeth, OD: 8 5/8" (225mm).
$49.75
-
14126006
CLUTCH DISC
Planetary Brake, ID: 8 7/8" (225mm) 87 spline, OD: 11 1/2" (292mm), Thk: 13/64" (5.2mm)
$57.63
-
14126016
CLUTCH DISC
ID: 4 7/16" (113mm) w/ 54 teeth, OD: 11 3/16" (285mm)
$66.09
-
14126017
CLUTCH DISC
ID: 9 3/16" (240mm) w/ 95 teeth, ID: 11 5/8" (295mm)
$43.24
-
14126033
CLUTCH PLATE
ID: 4 1/2" (140mm), OD: 9 7/8" (251mm) includes 12 tabs.
$50.04
-
14126044
CLUTCH PLATE
ID: 5 7/16" (138mm), OD: 8 1/2" (216mm) includes 12 tabs.
$33.14
- Found on Diagram:
Cooling System Components
-
14066206
WATER PUMP
Water pump with hub, replaces casting # R503509.
$209.29
-
-
-
- Found on Diagram:
Electrical Components
-
14000130
STARTER
12v, CW rotation, PLGR type starter w/3.0KW and 11 tooth drive. Two ear mount.
$357.56
-
14000195
STARTER
12v, 3.4kw, 10 tooth, clockwise, PLGR, OE Iskra (Mahle)
$557.21
-
14000524
ALTERNATOR
12v, 150 amps, IR/IF, CW rotation, neg ground, A-Circuit regulator..
$355.27
-
14000528
ALTERNATOR
12V, 120a, IR, IF, clockwise, Bosch unit, less pulley.
$606.93
-
14000529
ALTERNATOR
12V, I/R, 90 Amp unit w/eight groove serpentine pulley
$369.48
-
14000945
No Longer Available
- Found on Diagram:
Engine Components
-
-
-
-
-
14095100
FLYWHEEL W/RING GEAR
Fits with 12", 12-5/8" and 12-7/8" Pressure Plate Assemblies. Flywheel has 13" I.D and does come with Ring Gear. Flywheel ring gear w/142 teeth, OD is 14.325" by ID of 13.370" by Width of .406" replaces ref#T20088.
$584.94
-
-
14095500
RING GEAR
Flywheel ring gear w/142 teeth, OD is 14.325" by ID of 13.370" by Width of .406". Replaces ref#T20088, used w/flywheel ref#RE18678.
$46.71
-
14095512
BELT
97 7/16" (2475 mm), 8 rib serpentine belt.
$35.78
-
- Found on Diagram:
Filters
-
AF3717
AIR FILTER
This filter is currently available in Baldwin brand.
$75.28
-
AF9000
AIR FILTER
This filter is currently available in Baldwin brand.
$146.94
-
-
HF1409
LUBE FILTER
OD: 3-3/4 (95.3), Length: 9-19/32 (243.7), Thread: 1-3/8 x 12 UNF. Lube filter for diesel and gas applications.
$43.24
-
HF6604
LUBE FILTER
This filter is currently available in Baldwin brand.
$68.71
-
-
- Found on Diagram:
Front Axle & Steering Components
-
14041004
SPINDLE
LH/RH, pivot shaft 9.3" (236mm) long
$408.17
-
-
-
14041027
BALL JOINT
Tie rod end, for units with 733 (Dana) MFWD axle and tie rod AL166369
$213.19
-
14041031
TIE ROD END
LOA: 26.25" (666.75mm), OD: 1.25" (31.75mm)
$314.79
-
14041036
TUBE
LOA: 38 1/4", ID: M24 x 2.0 female RH thread
$110.55
-
14041064
AXIAL JOINT
8.20", M22 X 1.5 RH Thrd, M24 X 1.5 RH Thrd
$112.62
-
-
14041077
TIE ROD END
LOA: 10", ID: M24 X 1.5 RH Thread, right side
$194.98
-
-
-
-
-
-
-
-
-
- Found on Diagram:
Fuel System Components
-
-
-
-
14033004
FUEL PUMP
Electric fuel pump, 59.97 GPH (227 LPH). 2 pin connector.
$119.12
-
-
-
14033705
INJECTOR
Pencil type, for 350 series diesel motors. Stamped Id # 28478.
$57.02
- Found on Diagram:
Hitch and Implement Components
-
14130002
LIFT LINKAGE
Three point hitch top link category 2 with ball and hook ends, Cat ll, min 20.86"-max 28.54".
$357.12
-
-
- Found on Diagram:
Muffler
-
14172799
MUFFLER
Underhood Muffler, exhaust to right.
$281.68
- Found on Diagram:
Seals
-
30210025
SEAL
ID: 150mm OD: 180mm W: 14.5/16mm
$60.58
-
30210027
SEAL
ID: 1.93" (49mm), OD: 2.56/2.68" (65/68mm), W: 0.39/0.53" (10/13.5mm)
$38.10
- Found on Diagram:
Sheet Metal and Grille
-
- Found on Diagram:
Wheels, Hubs and Components
-
14080001
HUB
2WD wheel hub, implement hub, 8 hole pattern
$115.58