JavaScript Disabled - Unable to show Cart
There are (56) parts used by this model.
- Found on Diagram:
Brake
-
11022005
SPRING
Brake shoe adjusting screw spring
$5.41
-
11022006
SPRING
Brake shoe retracting spring, 1955 to 1964 four cylinder models.
$21.57
-
11022008
BRAKE SPRING KIT
Brake Shoe Spring & Retainer Kit (does not include brake shoes). Contains: 1 8N2048 socket, 4 6H2066 brake spring cup, 2 NCA2204A spring, 1 NCA2217A dust seal, 1 NCA2296B spring, 2 NCA2333A pin, 2 NCA22219A spring, 2 NCA22275A spring, 2 NCA22276A pin, 2 NCA22218A collar, 2 NCA22286A retainer, 1 H204
$81.18
- Found on Diagram:
Clutch, Transmission & PTO
-
-
11125989
CLUTCH KIT
Single clutch kit w/10" 15 spline spring drive disc E8NN7550FA, 10" single pressure plate NDA7563A, pilot bearing C5NN7600A and release bearing C0NN7580A, includes pilot tool.
$224.18
-
-
-
11126009
PILOT BEARING
ID: 0.66" (16.992mm), OD: 1.57" (40.005mm), W: 0.47" (11.988mm), double seal.
$5.24
-
11126066
CLUTCH PLATE DOUBLE
Double Clutch Assembly. Includes captive 9" 15 spline drive disc, captive 9" 29 spline PTO disc. Fits models with Live PTO and 5 speed transmission.
$623.04
-
-
11126100
CLUTCH KIT
Kit contains 9", 15 spline drive disc w/29 spline double pressure plate 311435 assembly, includes pilot bearing C5NN7600A and release bearing 83914247. Note: Pilot Tool is not included and not needed in this kit.
$593.75
-
11126628
SEAL
Single Lip Oil seal, transmission drive gear, trans input shaft, also for combination trans Step Up/Down. ID: 1.375" (34.93mm), OD: 2.004" (50.9mm), W: 0.328" (8.33mm)
$6.39
-
12126007
CLUTCH DISC
Friction Disc, ID: 3.65" (92.7mm) w/ 45 teeth, OD: 5.24" (133.1mm), Ht: .0629" (1.6mm)
$23.61
- Found on Diagram:
Cooling
-
11066303
RADIATOR
Eight (8) fins per inch. Core is 17-1/2" tall, 15-1/4" wide, 2-1/4" thick. W/cap. Copper core.
$329.36
-
12060156
INLET HOSE
ID: 2"(50MM) L: 2.375" (60.00mm), OD: 2.4" (60.97mm)
$7.17
- Found on Diagram:
Electrical
-
11000121
STARTER
6/12v, DD, CW rotation. Uses NCA11450A solenoid and 1CM11350A drive. WARNING: Failure to disengage starter drive from flywheel prior to push starting tractor will result in damage to starter drive, starter, and flywheel. Do not spin starter drive by hand. Warranty does not cover bent armature, broke
$158.13
-
11000121D
STARTER W/DRIVE
6 VOLT ONLY, DD, CW rotation. 1CM11350C drive installed. Uses NCA11450A solenoid. FOR 12 VOLT VERSION USE 1100-0123D. WARNING: Failure to disengage starter drive from flywheel prior to push starting tractor will result in damage to starter drive, starter, and flywheel. Do not spin starter drive by h
$189.08
-
11000123D
STARTER W/DRIVE
12v, DD, CW rotation. 1CM11350C drive installed. Uses 311006 solenoid. WARNING: Failure to disengage starter drive from flywheel prior to push starting tractor will result in damage to starter drive, starter, and flywheel. Do not spin starter drive by hand. Warranty does not cover bent armature, bro
$177.64
-
11000307
STARTER DRIVE
9 tooth, CCW, 29 spline, 15.9mm ID, 123-140mm L, pin mount, 21.5mm pinion length. Locking barrel-folo design. WARNING: Failure to disengage starter drive from flywheel prior to push starting tractor will result in damage to starter drive, starter, and flywheel. Do not spin starter drive by hand. War
$42.01
-
11000565
REGULATOR
12v, 14.5 Volt set. B Circuit, Neg (-) or Pos (+) ground. Terminals are ARM - FIELD - BAT.
$51.48
-
-
11000951
IGNITION KEY
Spare key. For 8N3679C. Priced individually but sold in multiples of 2.
$1.09
-
11006005
REAR LAMP LENS
Red Lens, tail light / brake light lens, fits original style housing.
$24.29
-
- Found on Diagram:
Engine
-
11091322
VALVE SPRING
Spring, intake and exhaust valve (8 used per engine)
$3.52
-
11099416
EXHAUST GASKET KIT
Kit includes (2) C0NN9448C manifold gaskets and (2) NAA55232A muffler gaskets
$4.91
-
-
-
-
- Found on Diagram:
Front Axle & Steering
-
11044097
STEERING SHAFT
Ball Nut and Shaft assembly (w/ std. steering). LOA: 23.5" (597mm), 36 spline, 11/16" 20 UNF thread.
$243.29
-
- Found on Diagram:
Fuel
-
11030003
CARBURETOR
Mounting Bolts CTC is 2-3/8" for 134 engines only. Note: New carbs are not adjusted to new specs due to age and wear variances of tractors, may need to adjust mixture, idle, and float adjustments.
$294.69
-
11030051
CARB FLOAT
Brass material float chambers. W/o pin.
$12.25
-
11033381
O RING SEAL
Sold in Packs of 2 but priced individually. 3/8" fiber washer for Banjo Bolt 3133382 or 86531362.
$0.70
-
11033382
O RING SEAL
Sold in Packs of 2 but priced individually. 7/16" fiber washer for Banjo Bolt C0NN9A349B.
$1.07
-
-
-
11033393
GLASS BOWL
Glass Sediment Bowl for 311272 and CONN9155A Fuel Strainer Assemblies. 1 1/2" diameter bottom and 1 7/8" Long.
$11.25
-
11033394
SEDIMENT BOWL
For 134 CID gasoline motors, mounts to carburetor w/3/8" opening. Top lip of bowl 1-1/2" OD. Comes with Glass bowl not plastic.
$36.94
-
11033395
SEDIMENT BOWL
For models listed 1960~65, 7/16" opening, mounted to carburetor.
$34.97
-
11033402
FUEL CAP
Fuel cap for self venting tanks. Cap is non-vented. For vented cap use C5NN9030B.
$9.06
-
11033431
FUEL LINE
1/4" For Tractors with 134 CU. IN Engine. 1/2" x 20 pitch fittings.
$45.03
-
11033432
FUEL LINE
5/16" Fuel Line for Tractors with 172 CU. IN Engine.
$34.01
- Found on Diagram:
Gauges, Instruments, Cables
-
-
11072707
TACHOMETER
Tach, Proofmeter, CCW rotation, models with 10 speed transmission, '59 - '64 (will not replace C3NN17635A for Offset models or NAA)
$59.61
- Found on Diagram:
Hitch and Implement
-
-
11131071
CHECK CHAIN KIT
Drawbar check chain kit includes: RH/LH anchors, 2 eyelets, 2 chains, 4 clevis with pins and hdw
$41.07
- Found on Diagram:
Hydraulic & Power Steering
-
-
-
- Found on Diagram:
Manuals & Decals
-
- Found on Diagram:
Sheet Metal and Grille
-
11111457
SIDE PANEL
Side panel assembly, front RH lower Shipped with a protective primer finish allowing for a better match to exact paint scheme
$145.11
-
11111461
TOOL BOX
Tool box is fender mounted. May need to be painted for color matching.
$49.30
-
11116563
SIDE PANEL
Side panel assembly, front LH lower. Shipped with a protective primer finish allowing for a better match to exact paint scheme.
$149.47
- Found on Diagram:
Wheels, Hubs
-
30081019
RIM
16x4.5, 4 5/8" Pilot, 6 Lug
$80.09