How to Check and Replace the Spark Plug on Your Troy-Bilt 4-Cycle String Trimmer
August 19th, 2016 | by Brandon
If your spark plug is fouled in any way, it can cause your equipment to be unable to start. Replacing ...
String Trimmer
How to Clean and Replace the Air Filter on Your Troy-Bilt 4-Cycle String Trimmer
August 17th, 2016 | by Brandon
A dirty or damaged air filter can cause irreversible engine damage if not regularly inspected, cleaned, and replaced when needed. ...
How to Check and Change the Oil of Your Troy-Bilt 4-Cycle String Trimmer
August 17th, 2016 | by Brandon
Regularly check, change, and add oil to your engine if needed. Keeping up with oil changes will greatly increase the ...
How to Replace the Trimming Line of Your Troy-Bilt 4-Cycle String Trimmer
August 17th, 2016 | by Brandon
Replenishing your trimming line is often an annoying yet necessary task to deal with when trimming on a regular basis. ...
How to Remove Old Trimming Line from Your Troy-Bilt 4-Cycle String Trimmer
August 17th, 2016 | by Brandon
When installing new trimming line, it’s sometimes necessary to remove/clean any old trimming line and other obstructions that may be ...
How to Install and Adjust the Handle on Your Troy-Bilt 4-Cycle String Trimmer
August 17th, 2016 | by Brandon
Install and adjust the handle on your Troy-Bilt string trimmer for the best possible user experience. Learn how to customize ...
How to Operate an MTD String Trimmer
June 19th, 2015 | by Kimberly Myers
To start the trimmer: Check the oil level in the crankcase Fill the gas tank with unleaded, fresh, gasoline Make ...
How to Operate a Redmax String Trimmer
June 19th, 2015 | by Kimberly Myers
Starting Engine: Check oil in crank case Fill the tank up with fresh unleaded fuel Rest on a flat, firm ...
How to Operate a Poulan String Trimmer
June 10th, 2015 | by Kimberly Myers
To Start: Set the unit on a flat surface Slowly press the primer bulb 6 times Move the choke lever ...
How to Operate a Husqvarna String Trimmer
June 10th, 2015 | by Kimberly Myers
To Start the Engine: Cold Engine: Press the primer bulb 10 times until fuel begins to fill the bulb, the ...
12