How to Stop the Engine for a Husqvarna R120S
The following instructions are for the Husqvarna Rider, which is for the model number R120S. Before attempting to work on/with your equipment in any way, always refer to your owner’s manual for safety information.
- Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard.
- Lift up the cutting unit by pulling the lever backwards to its locked position.
- Pull back the throttle and let the motor idle for at least 30 seconds.
- Turn the ignition key to the “STOP”.
- When the Rider is at a standstill, press down the parking brake and push in the locking button.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Adjust the Throttle Wire for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
How to Replace the Transmission Poly-V Belt for a Snapper P2185020 →
One Response to How to Stop the Engine for a Husqvarna R120S