How to Adjust the Throttle Wire for a Husqvarna R120S
The following instructions are for the Husqvarna Rider, which is for the model number R120S. Before attempting to work on/with your equipment in any way, always refer to your owner’s manual for safety information.
- Release the clamping screw that secures the wire casing ans set the choke control to maximum choke.
- Pull the choke wire casing to the far right and tighten the clamping screw.
- Pull back the throttle to the full throttle position and check that the choke is no longer actuated.
For information about safety, warranty, and your specific model, read and be familiar with your owner’s manual.
Related Products and Links
Related Posts
How to Install the Grass Bag for a Snapper P2185020 →
How to Stop the Engine for a Husqvarna R120S →
How to Replace the Bearing on the Pulley End of the Hex Shaft for a Snapper P2185020 →
How to Replace the Transmission Poly-V Belt for a Snapper P2185020 →
