Changing the Spark Plug on a Generac iX2000 Generator
Watch our video on how to replace the spark plug on a Generac iX2000 generator.
Changing your spark plug will increase the efficiency and extend the life of your engine.
This video shows you how to easily replace your dirty spark plug with a new one.
Step 1:
Be sure the power switch is off and that all power cords are disconnected
Step 2:
Remove the spark plug maintenance cover and disconnect the spark plug boot
Step 3:
Use a socket wrench or spark plug wrench to remove the spark plug
Step 4:
Check the gauge of your new spark plug (see owner’s manual for information)
Step 5:
Thread the new plug into the housing and then using the wrench, finish tightening the spark plug, but do not over tighten
Step 6:
Reconnect the spark plug boot and maintenance cover
Jack’s Safety Tips: Before servicing or repairing any power equipment, disconnect the spark plug and battery cables. Remember to wear appropriate safety glasses and gloves to protect against harmful chemicals and debris. View our Disclaimer.
Featured Parts and Products:
- Model: Generac iX2000 Generator
- Spark Plug: #0H8096
- Generac Generator Parts
- Spark Plugs
- New Generac Generators
About the Author
Turner Anderson is the Internet Marketing Manager at Jack's and the editor of Jack's DIY Center. You'll also find him creating How-To articles, videos, newsletters, and much more.
Related Posts
How to Replace the Spark Plug and Check the Ignition Spark on Your Makita 2-Stroke Chainsaw →
How to Inspect and Replace the Spark Plug on Your Honda Two Stage Snow Blower →
How to Check and Replace the Spark Plug on Your Troy-Bilt 4-Cycle String Trimmer →
How to Replace the Spark Plug on Your Craftsman Dual-Stage Snow Blower →
